< 50
50 ~ 100
100 ~ 250
250 ~ 400
400 ~ 600
> 600
1
1
1
1
1
1,5
11
16
20
22
25
32
10 -0,1
12,5 -0,1
16 -0,1
20 -0,2
22 -0,2
25 -0,2
1,2
1,5
2,0
2,2
2,5
3,2
ØD = H8
| Lead in champfer | (length of lead champfer mm) | |||||
| W=30° | W=25° | W=20° | W=15° | |||
| Ød h8 (shaft Ø mm) | Ø dm max. | L | L | L | L | R |
| up 30 - 40 | d-3,0 | 2,6 | 3,2 | 4,1 | 5,6 | 3,0 |
| up 40 - 50 | d- 3,5 | 3,0 | 3,7 | 4,8 | 6,5 | 3,5 |
| up 50 - 70 | d- 4,0 | 3,5 | 4,3 | 5,5 | 7,5 | 3,5 |
| up 70 - 95 | d- 4,5 | 4,0 | 4,8 | 6,2 | 8,4 | 4,0 |
| up 95 - 130 | d- 5,5 | 4,8 | 5,9 | 7,6 | 10,3 | 5,0 |
| up 130 - 240 | d- 7,0 | 6,0 | 7,5 | 9,6 | 13 | 6,0 |
| up 240 - 400 | d-11 | 9,5 | 11,8 | 15,1 | 20,5 | 10 |
| > 400 | d-12,5 | 10,8 | 13,4 | 17,2 | 23,3 | 10 |
execution notes for shaft treatment:
Surface treatment of the shaft has to be done acc. DIN 3760 and ISO 6194 / 1.
| surface quality of the shaft: | "plunge grinded" |
| under consideration of following surface roughness: | Rt =1 - 4 acc. DIN 3760 |
| Ra = 0,2 - 0,63 µm | |
| Rz = 1,2 - 3,0 µm acc. ISO 6194/1-2007 | |
| Hardness of surface: | nominal 45 HRc |
| minimum 30 HRc |
As there are many unknown possible parameters and conditions in practice, which may limit standard performance, it is requested that the user runs practical tests.
Except as expressly stated, Friedrich‘s liability, expressed or implied, is limited to the published selling price of our defective item.
© Issued under copyright and must not be used for any purpose without written permission from the copyright owner.
025_einbaumassen-10+11_e
© 2020 by FDI® - Design